20g tablets for disinfection and algae control.

20g tablets for disinfection and algae control. Ideal for long-term and even disinfection of swimming pool water. Tablets; practical and easy to dose. Preventive effect against algae and organic dirt/load. Stabilizer protects chlorine from UV radiation from the sun. High stable chlorine content: Min. 90%. For application in soft and hard water.

Dosing instructions (practical advice):

• Always correct the pH value between 7.2 and 7.6
• Dissolve the tablet(s) in the dosing float or skimmer
• Maintain the chlorine level around 2 to max. 5 ppm (mg/l). The dosage depends strongly on circumstances (temperature, sun and bath load)
• 10 tablets per 30-35 m³ of water every 3-5 days
• With this dosing recommendation, the cyanuric acid content may not exceed 70 ppm (mg/l) (overstabilisation)
• May differ from label texts. Labels are always drawn up according to national rules and regulations

Warning:

• Use biocides safely. Always read the label and product information before use
• Keep in a cool dark place, out of the reach of children
• Do not throw the tablets directly into the pool. You can easily get bleach stains and damage the bottom of your pool.
• Never mix with other (swimming pool) chemicals or other types of chlorine. These can react with each other. Chlorine gas formation may occur
• To avoid risk of skin and eye irritation, it is recommended to wear protective gloves and eye protection when handling this product

Tip:

• Note: Melpool 90/20 contains a chlorine stabilizer (cyanuric acid). This stabilizer protects the dissolved chlorine from UV rays from the sun that can quickly degrade the chlorine. With long-term dosing, the water can become over-stabilised, so that the chlorine is no longer sufficiently active. Therefore, regularly change part of the water
• Melpool 90/20 dissolves slowly. To quickly increase chlorine levels quickly (chlorine shock at season start or problems with algae/organic load) dose Melpool 70/G or Melpool 55/G
• If a floating dispenser is used, make sure that it receives sufficient flow. Otherwise the tablets will not dissolve properly and quickly enough!